Fuel R14K/600 (4MB), V12, Revolution 7.1, Copper SGI Gbit, QLA12160/66, 6.5.26m.

Location: /hw/module/001c01/node
            IP34 Board: barcode MFB289     part 030-1707-003 rev -G
Location: /hw/module/001c01/node/cpubus/0
        IP34PIMM Board: barcode NEY877     part 030-1730-002 rev -E
Location: /hw/module/001c01/Ibrick/xtalk/13
          ASTODY Board: barcode MMM204     part 030-1726-003 rev -E
Location: /hw/module/001c01/Ibrick/xtalk/14
            IP34 Board: barcode MFB289     part 030-1707-003 rev -G
Location: /hw/module/001c01/Ibrick/xtalk/15
            IP34 Board: barcode MFB289     part 030-1707-003 rev -G
1 600 MHZ IP35 Processor
CPU: MIPS R14000 Processor Chip Revision: 2.4
FPU: MIPS R14010 Floating Point Chip Revision: 2.4
CPU 0 at Module 001c01/Slot 0/Slice A: 600 Mhz MIPS R14000 Processor Chip (enabled) 
  Processor revision: 2.4. Scache: Size 4 MB Speed 300 Mhz  Tap 0xa
Main memory size: 2048 Mbytes
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 4 Mbytes
Memory at Module 001c01/Slot 0: 2048 MB (enabled)
  Bank 0 contains 1024 MB (Premium) DIMMS (enabled)
  Bank 1 contains 1024 MB (Premium) DIMMS (enabled)
Integral SCSI controller 2: Version QL12160, low voltage differential
Integral SCSI controller 3: Version QL12160, low voltage differential
Integral SCSI controller 0: Version QL12160, low voltage differential
  Disk drive: unit 1 on SCSI controller 0 (unit 1)
Integral SCSI controller 1: Version QL12160, low voltage differential
IOC3/IOC4 serial port: tty1
IOC3/IOC4 serial port: tty2
IOC3 parallel port: plp1
Graphics board: V12
Gigabit Ethernet: eg0, module 001c01, pci_bus 1, pci_slot 3, firmware version 12.4.10
Integral Fast Ethernet: ef0, version 1, module 001c01, pci 4
Iris Audio Processor: version MAD revision 1, number 1
  PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 1
  PCI Adapter ID (vendor 0x1077, device 0x1216) PCI slot 1
  PCI Adapter ID (vendor 0x1412, device 0x1724) PCI slot 2
  PCI Adapter ID (vendor 0x10a9, device 0x0009) PCI slot 3
  PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 4
  PCI Adapter ID (vendor 0x11c1, device 0x5802) PCI slot 5
HUB in Module 001c01/Slot 0: Revision 2 Speed 200.00 Mhz (enabled)
IP35prom in Module 001c01/Slot n0: Revision 6.210
USB controller: type OHCI

Graphics board 0 is "ODYSSEY" graphics.
        Unmanaged 1280x1024 
        BUZZ version B.1
        PB&J version 1
        128MB memory
                Banks: 4, CAS latency: 3
         Monitor 0 type: Unknown
        Xvc info not available for unmanaged boards

System disk = Seagate 36GB 10K SCA ST336704LCV