Tested 29/Nov/07, by Ian Mapleson Origin200, Dual-R12K/270 (4MB), 256MB RAM, 18GB 10K disk, 6.5.26m. Location: /hw/module/1/slot/MotherBoard/node PIMM_270_4M_2P Board: barcode LZN520 part 013-2511-001 rev D Location: /hw/module/1/slot/MotherBoard/node/xtalk/8 IP29 Board: barcode JRW205 part 030-1389-001 rev B Location: /hw/module/1/slot/MotherBoard/node/xtalk/8/pci/2 2 270 MHZ IP27 Processors CPU: MIPS R12000 Processor Chip Revision: 2.3 FPU: MIPS R12010 Floating Point Chip Revision: 2.3 CPU 0 at Module 1/Slot 1/Slice A: 270 Mhz MIPS R12000 Processor Chip (enabled) Processor revision: 2.3. Scache: Size 4 MB Speed 180 Mhz Tap 0x9 CPU 1 at Module 1/Slot 1/Slice B: 270 Mhz MIPS R12000 Processor Chip (enabled) Processor revision: 2.3. Scache: Size 4 MB Speed 180 Mhz Tap 0x9 Main memory size: 256 Mbytes Instruction cache size: 32 Kbytes Data cache size: 32 Kbytes Secondary unified instruction/data cache size: 4 Mbytes Memory at Module 1/Slot 1: 256 MB (enabled) Bank 0 contains 128 MB (Standard) DIMMS (enabled) Bank 1 contains 128 MB (Standard) DIMMS (enabled) Integral SCSI controller 0: Version QL1040B (rev. 2), single ended Disk drive: unit 1 on SCSI controller 0 (unit 1) Disk drive: unit 2 on SCSI controller 0 (unit 2) Integral SCSI controller 1: Version QL1040B (rev. 2), single ended IOC3/IOC4 serial port: tty1 IOC3/IOC4 serial port: tty2 IOC3 parallel port: plp1 Integral Fast Ethernet: ef0, version 1, module 1, slot MotherBoard, pci 2 Origin 200 base I/O, module 1 slot 1 PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 2 PCI Adapter ID (vendor 0x1077, device 0x1020) PCI slot 0 PCI Adapter ID (vendor 0x1077, device 0x1020) PCI slot 1 IOC3/IOC4 external interrupts: 1 HUB in Module 1/Slot 1: Revision 5 Speed 90.00 Mhz (enabled) IP27prom in Module 1/Slot n1: Revision 6.156 Redundant Power Supply in Module 1 (Lost Redundancy)